config USB_KAWETH tristate 'USB KLSI KL5USB101-based ethernet device support' -help- Say Y here if you want to use one of the following 10Mbps only USB Ethernet adapters based on the KLSI KL5KUSB101B chipset: 3Com 3C19250 ADS USB-10BT ATEN USB Ethernet ASANTE USB To Ethernet Adapter AOX Endpoints USB Ethernet Correga K.K. To compile this driver as a module, choose M here: the module will be called catc. Supported devices are: Belkin F5U011 Belkin F5U111 CATC NetMate CATC NetMate II smartBridges smartNIC This driver makes the adapter appear as a normal Ethernet interface, typically on eth0, if it is the only ethernet device, or perhaps on eth1, if you have a PCI or ISA ethernet card installed. # USB Network devices configuration # comment 'Host-side USB support is needed for USB Network Adapter support' depends on ! USB & NET menuconfig USB_NET_DRIVERS tristate 'USB Network Adapters' default USB if USB depends on USB & NET if USB_NET_DRIVERS config USB_CATC tristate 'USB CATC NetMate-based Ethernet device support' select CRC32 -help- Say Y if you want to use one of the following 10Mbps USB Ethernet device based on the EL1210A chip.
